![]() ![]()
Wd my passport studio not showing up mac shutdown how to#Check with the manufacturer on how to do this, but it usually involves unplugging the device for a set amount of time, and pressing a combination of buttons or a small, hidden reset button on the device. Lastly, try resetting the device, since a firmware fault could cause communications and power management errors. Connect the drive directly to the Mac and avoid daisy-chaining it to other devices. In addition to ensuring the drive is getting adequate power, try checking the cables for the drive by swapping them out. Therefore, plug it in if you have a power supply for it (many bus-powered drives ship with an optional one). If the drive is not getting enough power (especially true with bus-powered devices) then the device may unmount and fail. In addition to buttons getting stuck, drives may also stop working because of power problems and connection problems. It doesn’t register that the drive even exists, though the device connected noise sounds. Trying to use it on my girlfriend’s computer is a completely different matter. It has pretty much every bit of information I really hold dear, and on any mac computer I can find everything on it. I would recommend placing the drive against a firm surface like a table and then tapping it firmly with one or two fingers, as if you were striking a piano key loudly. So I have a My Passport drive that I had back before my mac computer killed itself. You can even utilize the Disk utility function, which is a built-in Mac to. While hard drives park their heads when powered down, a violent shock can still cause physical damage. Sometimes, this kind of problem can be because of missing the disk partition table. The same thing can sometimes happen if you are connecting a USB 3.0 device to a USB 2.0 port. If there is a problem with the USB cable or USB port the drive might not be able to work properly. ![]() Wd my passport studio not showing up mac shutdown portable#Be sure if you tap the drive that you do so firmly but not violently. My Passport drives are portable drives and as such are getting all the power they need from the USB port of the computer they are connected to. Once this has been done, plug it back in and start it up again, and hopefully the device will be working. The quick fix for this is to turn off and unplug the MyBook, and then give it a few sharp taps around the power button to dislodge it. While hard drives can fail at times for odd reasons, in this instance it turned out to be a problem with the drive's enclosure.Īpparently the power button on the MyBook enclosure can get stuck, and since holding the power button on many devices is a way to reset them or otherwise send custom commands to the firmware, this could cause the MyBook to power up but then stop communicating properly with the computer. This problem started happening after the system had been using the drive successfully for a while, and had performed numerous Time Machine backups to it. ![]() The drive would appear to start mounting or otherwise be recognized by the system, but then seem to hang and not be recognized. Recently we received an e-mail from a MacFixIt reader who wrote in with a fix he found for his Western Digital MyBook external hard drive that had stopped working. It was working before, now when I connect the cable to my laptop I get message 'Safely Remove hardware and Eject Media' but.In reality we do not recommend you "smack" your hard drive or other system components, but sometimes a little love tap or two can fix odd problems. Wd my passport studio not showing up mac shutdown windows 7#I am runing Windows 7 and connected to USB3.0 port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |